CTS V6-2.8L (2006)
Seat Belt: Service and Repair
Front
SEAT BELT REPLACEMENT - FRONT
REMOVAL PROCEDURE
1. Remove the front seat back trim cover.
CAUTION: Refer to SIR Caution in Service Precautions.
2. Remove the front seat cover and pad.
3. Remove the screws retaining the roller assembly cover and remove the cover.
4. Remove the bolt retaining the seat belt retractor to the seat frame.
5. Remove the seat belt lower retaining nut (2).
6. Remove the seat belt retractor assembly.
INSTALLATION PROCEDURE
1. Ensure that the seat belt is not twisted before installing the retractor.
2. Install the seat belt (2) to the mounting stud.Ensure that the anti-rotation tab on the seat belt is located properly in the seat frame before tightening
the retaining nut.
3. Install the retaining nut.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nut to 42 N.m (31 lb ft).
4. Position the seat belt over the roller assembly.Ensure that the seat belt is not twisted.