CTS V6-2.8L (2006)
Wheel Fastener: Service and Repair
Rear Suspension
Wheel Stud Replacement
^
Tools Required
-
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle.
2. Remove the tire and wheel.
3. Remove the wheel bearing/hub assembly.
4. Using J 43631 remove the wheel stud from the wheel bearing.
Installation Procedure
1. Install the new stud from the back side of the hub.
2. Install flat washers on the wheel stud.
3. With the flat side of a wheel nut against the washers, tighten the wheel nut until the wheel stud head seats against the wheel hub flange.
Important: Ensure that the wheel stud is fully seated against the wheel hub flange.
4. Install the wheel bearing/hub assembly.
5. Install the tire and wheel.
6. Lower the vehicle.