CTS V6-2.8L (2006)
Seals and Gaskets: Service and Repair
Drive Flange and Seal Replacement
Drive Flange and Seal Replacement
Tools Required
^
J6125-1B Slide Hammer
^
J23129 Universal Seal Remover
^
J29873 Injector Nozzle Socket 30 mm
^
J44765 Seal Installer
^
J45012 Holding Fixture
^
J45019 Universal Puller
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the transmission manual shift shaft nut.
3. Disconnect the shift linkage from the transmission.
4. Place the transmission in neutral by rotating the transmission shift shaft clockwise 2 clicks.
5. Remove the exhaust system.
6. Disconnect the propeller shaft coupler (1) from the transmission flange.
7. Push the front propeller shaft toward the rear of the vehicle in order to release the propeller shaft coupler (1) from the transmission drive flange.
8. Secure the front propeller shaft (1) to the shift control lever (3) with a piece of mechanics wire (2).