CTS V6-2.8L (2006)
12. Stroke the joint to dimension A of 271 mm (10.7 inch).
Important: The inner boot must not be dimpled, stretched, or out of shape in any way. If necessary, equalize the air pressure in the inner boot and
shape properly by hand.
13. Crimp the large boot retaining clamp using J35910 with a breaker bar and torque wrench.
Tighten to 176 Nm (130 ft. lbs.).
14. Torque until the proper gap dimension of 1.9 mm (0.075 inch) is reached.
15. Fully stroke the cross groove joint several times to disperse grease throughout the joint.
16. Install the halfshaft from the vehicle.