CTS V6-3.2L VIN N (2003)
Body Emblem: Service and Repair
Emblem/Nameplate Replacement - Rear Compartment Lid (w/o B57)
Emblem/Nameplate Replacement - Rear Compartment Lid (w/o B57)
Tools Required
J 25070 Heat Gun
Removal Procedure
Important: Apply the tape for protection and alignment marks for alignment of the new emblem/nameplate.
1. Apply the tape to the area around the emblem/nameplate.
2. Heat the emblem/nameplate using theJ 25070 . Apply the heat using a circular motion for about 30 seconds holding the heat gun 152 mm (6 in)
from the surface.
3. Remove the emblem/nameplate from the surface using a small plastic flat-bladed tool, being careful not to damage the paint.
4. When replacing a emblem/nameplate, remove all adhesive as follows:
*
For body panels, use a 3M(TM) Scotch Brite molding adhesive remover disk 3M(TM) P/N 07502 or equivalent.
*
For plastic panels, use a lint-free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol
and water to remove the adhesive.
Installation Procedure
Important: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the
sticky backing. Foreign material may cause improper adhesion.
