CTS V6-3.2L VIN N (2003)
Power Seat Motor Position Sensor: Service and Repair
Sensor Replacement - Seat Adjuster Motor - Horizontal
SENSOR REPLACEMENT - SEAT ADJUSTER MOTOR - HORIZONTAL
REMOVAL PROCEDURE
1.
CAUTION: Refer to SIR Caution in Service Precautions.
Disable the SIR system.
2. Remove the seat cushion to gain access to the horizontal seat adjuster motor.
3. Disconnect the electrical connectors from the motor.
4. Remove the seat adjuster drive cable (1) by pulling the cable out of the motor.
5. Remove the sensor from the motor.
INSTALLATION PROCEDURE
1. Install the sensor to the motor.
2. Line up the square end of the cable with the motor.
3. Install the long drive cable (1) into the motor.
4. Install the long cable into the seat adjuster.
5. Ensure the cable isfully seated.
6. Connect the electrical connectors.
7. Install the seat cushion.
8. Enable the SIR system.