CTS V6-3.2L VIN N (2003)
Center Mounted Brake Lamp: Service and Repair
HIGH MOUNTED STOP LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Open the rear compartment.
2. Remove the rear compartment lid applique.
3. Disconnect the high mounted stoplamp connector from the wiring harness.
4. Remove the fasteners securing the high mounted stoplamp to the rear compartment lid applique.
5. Remove the high mounted stoplamp from the rear compartment lid applique and place it face down on a clean protective surface.
INSTALLATION PROCEDURE
1. Install the high mount stoplamp to the rear compartment lid applique.
2. Install the fasteners in order to secure the high mounted stoplamp to the rear compartment lid applique.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the high mounted stoplamp fasteners to 6 N.m (53 lb in).
3. Connect the high mount stoplamp electrical connector.
4. Install the rear compartment lid applique to the rear compartment lid.
5. Close the rear compartment.