CTS V6-3.2L VIN N (2003)
Crankcase Vent: Service and Repair
Crankcase Vent Housing
Crankcase Vent Housing Replacement
Removal Procedure
1. Remove the following components according to the RPO code:
See: Application and ID
LHD
-
The air inlet grill panel.
-
The fasteners securing the front air inlet panel assembly to the battery tray and cowl.
-
The front air inlet panel assembly from the vehicle.
RHD
-
The wiper motor module.
2. Disconnect the electrical connector (2) from the coil pack (1).
3. Remove the heated oxygen sensor connector (1) from the bracket (3).
4. Remove the bolt securing the surge tank outlet pipe to the vent housing-LHD ONLY.