CTS V6-3.2L VIN N (2003)
INSTALLATION PROCEDURE
1. Apply a few drops of clean engine oil to the male pipe end.
CAUTION: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean
engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
2. Push both sides of the quick-connect fitting together to cause the retaining tabs to snap into place.
3. Pull on both sides of the quick-connect fitting to make sure the connection is secure.
4. Install the retainer to the quick-connect fitting.
5. Inspect for leaks using the following procedure:
5.1.
Turn the ignition ON, with the engine OFF for 2 seconds.
5.2.
Turn the ignition OFF, for 10 seconds.
5.3.
Turn the ignition ON, with the engine OFF for 2 seconds.
5.4.
Turn the ignition OFF.
5.5.
Inspect for leaks.
