CTS V6-3.2L VIN N (2003)
Control Module HVAC: Service and Repair
Left Hand Drive
BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT (LHD)
REMOVAL PROCEDURE
1. Remove the right sound insulator.
2. Disconnect the electrical connector from the blower motor control processor.
3. Remove the blower motor control processor retaining screw (1).
4. Remove the blower motor control processor from the vehicle.
INSTALLATION PROCEDURE
1. Install the blower motor control processor.
2. Install the blower motor control processor retaining screw.
NOTE: Refer to Fastener Notice
Tighten
Tighten the screw to 1 N.m (9 lb in).
