CTS V6-3.2L VIN N (2003)
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Install the SIS (1) to the center pillar.
3. Install the SIS mounting fasteners (2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the fasteners to 9 N.m (80 lb in).
4. Install the harness connector (2) to the SIS (3).
5. Install the CPA (1) to the SIS harness connector (2).
6. Install the center pillar trim.
7. Move the seat to the original position.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 or SIR Disabling and Enabling Zone 6.