CTS V6-3.2L VIN N (2003)
25. From the technicians point of view, the FRONT of the sensor will have:
-
A flush rotor flange cuff (4)
-
A pin hole (2) for the centering pin--Note the location of the pin hole.
-
An alignment mark (3) on the flush rotor flange cuff (4) for installation
-
A foam ring (1)
26. Remove the connector from the sensor.
27. Remove the sensor from the adapter and bearing assembly.
28. To install the sensor, proceed to step 21 in the installation procedure.
Installation Procedure
