CTS V6-3.2L VIN N (2003)
Seals and Gaskets: Service and Repair
Extension Housing and Seal Replacement
Extension Housing and Seal Replacement
Removal Procedure
1. Remove the drive flange (2). The output shaft retainer (1) will slide off the output shaft while removing the case extension housing.
2. Place a suitable transmission jack under the transmission pan to support the transmission.
3. Remove the transmission support.
4. Place an oil drain pan under the case extension housing.
5. Remove the bolts (1) from the case extension housing.
6. The output shaft retainer will slide off the output shaft while removing the case extension housing. Remove the case extension housing (2) and the
gasket seal (3).
Installation Procedure