CTS V6-3.2L VIN N (2003)
5. Connect the clutch hydraulic hose.
6. Install the coolant surge tank.
7. Install the clutch fluid reservoir to the fender reinforcement.
Notice: Refer to Fastener Notice in Service Precautions.
8. Install the clutch fluid reservoir bolt.
Tighten the bolt to 50 Nm (37 ft. lbs.).
9. Position the clutch master cylinder push rod to the clutch pedal pin.
10. Push the clutch master cylinder push rod onto the clutch pedal pin to secure.
11. Connect the clutch pedal position switch electrical connector.