CTS V6-3.2L VIN N (2003)
Technical Service Bulletin # 03-04-17-004
Date: 030227
Drivetrain - Revised Propeller Shaft Replacement
Bulletin No.: 03-04-17-004
Date: February 27, 2003
SERVICE MANUAL UPDATE
Subject:
Revised Propeller Shaft Replacement Procedure
Models:
2003 Cadillac CTS
This bulletin is being issued to revise the Propeller Shaft Replacement Procedure in the Driveline Axle sub-section of the Service Manual. Please replace
the current information in the Service Manual with the following information.
The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin
on the affected page.
Disclaimer
Propeller Shaft Replacement (Automatic Transmission)
Note:
There is a first and second design of the propeller shaft coupler-to-transmission/differential flange bolts used on this vehicle. Ensure the second
design propeller shaft coupler bolts are installed whenever the first design bolts are removed for service. The second design bolts must be
installed in a specific orientation per the procedure. If the incorrect bolts or the second design bolts are installed improperly, damage to the
propeller shaft coupler and/or the transmission may occur.
^
First design, fully threaded bolt (2).
^
Second design, shoulder bolt (1).
Removal Procedure
1.
Raise and support vehicle. Refer to Lifting and Jacking the Vehicle in the General Information sub-section of the Service Manual, SI Document #
813128.
2.
Remove the exhaust system. Refer to Exhaust System Replacement in the Engine Exhaust sub-section of the Service Manual, SI Document #
783469.
