CTS V6-3.2L VIN N (2003)
2. Install the drive flange to the transmission output shaft.
Important: Use a new drive flange nut. Do NOT reuse the old nut.
3. Apply gasket maker GM P/N 1052942 (Canadian P/N 10953466) to the sealing flange surface of the nut.
4. Apply thread locker GM P/N 12345382 (Canadian P/N 10953489) to the threads of the nut.
5. Install J45012 to the drive flange.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the new drive flange nut.
Tighten the drive flange nut using the J29873 while holding the J45012.
Tighten the drive flange nut to 100 Nm (74 ft. lbs.).
7. Remove J45012 from the drive flange.
