CTS V8-5.7L VIN P (2004)
IMPORTANT:
-
The RF connections for the inner antenna coupling should run parallel to the defogger gridline.
-
Align the inner and the outer antenna couplings.
-
Do not touch the adhesive backing on the antenna coupling.
1. Remove the protective film from the adhesive backing on the inner antenna coupling.
2. Align the inner antenna coupling either to the 4 locating marks on the rear window above the defogger gridline, or to the existing exterior
coupling.
3. Press firmly on all 4 corners and on the center of the antenna inner coupling (2) in order to ensure proper adhesion to the rear window (4). Hold
pressure on the inner coupling (2) for 10-30 seconds.
4. Ensure that no gaps occur between the couplings (2,5) and the rear window (4).
5. Connect the coaxial cable to the inner coupling (2).
6. Keep the vehicle dry. Allow 6 to 8 hours, at 15°C (60°F), for the adhesive to cure after installation.