CTS V8-5.7L VIN P (2004)
1. Ensure the area (1) where the emblem/nameplate (2) will be installed is clean and dry.
2. If the location of the emblem/nameplate has not been marked, apply tape and use the following dimensions:
*
24 mm (0.94 in) (a) from the horizontal edge of the rear compartment lid
*
209 mm (8.23 in) (b) from the vertical edge of the rear compartment lid
3. Heat the mounting surface to approximately 27-41°C (80-105°F) using theJ 25070 , if necessary.
4. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
Important: Do not touch the adhesive backing of the emblem/nameplate.
5. Remove the protective liner from the back of the emblem/nameplate (2).
6. Position the emblem/nameplate to the location marks (1) and press the emblem/nameplate to the mounting surface.
7. Apply equal pressure along the emblem/nameplate to uniformly bond the item to the mounting surface.