CTS V8-5.7L VIN P (2004)
Installation Procedure
1. Inspect the brake caliper guide pins. If damaged, or corroded replace the guide pin. Do not attempt to clean away any corrosion.
2. Install the brake pads (1) to the caliper.
3. Install the upper caliper guide pin (2) through the caliper, inner and outer brake pads.
4. Using a hammer and punch seat the upper guide pin (2) to the outer caliper half. Ensure that the caliper guide pin is seated into the outer caliper
pin seat.
5. Install the brake pad retainer (1) under the upper caliper pin assembly.
6. Rotate brake pad retainer (1) down.
7. Carefully apply pressure downward on the lower end of the brake pad retainer.
8. Carefully install the lower caliper guide pin (2) through the caliper, inner and outer brake pads.
9. Using a hammer and punch seat the upper guide pin (2) to the outer caliper half. Ensure that the caliper guide pin is seated into the outer caliper
pin seat. Ensure that the brake pad retainer is centered retaining both brake pads.
10. Install the tire and wheel.
11. Lower the vehicle.
12. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then repeat steps 15 and 16 until a firm brake pedal apply is obtained, this will properly seat the brake caliper pistons and brake
pads.
15. Fill the brake master cylinder reservoir to the proper level.
