CTS V8-5.7L VIN P (2004)
11. Tap the threaded end of the brake hose to caliper bolt (4) on the shop towel to remove the gasket (3) from the bolt.
12. Remove and discard the two copper brake hose gaskets (3). These gaskets may be stuck to the brake caliper (1) and/or the brake hose end (2).
13. Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and/or contamination.
Install a rubber plug into the brake hose to caliper bolt hole of the brake caliper.
Installation Procedure
1. Remove the rubber plug from the brake hose to caliper bolt hole of the brake caliper.
2. Important: Install NEW copper brake hose gaskets.
Assemble the brake hose, the NEW copper brake hose gaskets (3) and the brake hose bolt (4) to the brake hose (2).
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the brake hose to caliper bolt (4) to the brake caliper (1).
Tighten the brake hose to caliper bolt to 50 Nm (37 ft. lbs.).
4. Notice: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.
Install the brake hose (1) to the frame assembly (2).
5. Install the brake hose retainer (1) to the brake hose (3).
6. Remove the rubber cap or plug from the crossover pipe fitting end.
7. Install the brake pipe fitting (1) to the brake hose (3).