CTS V8-5.7L VIN P (2004)
Rear Engine Plate: Service and Repair
Engine Rear Cover Replacement
Removal Procedure
1. Remove the transmission clutch assembly.
3. Remove the oil pan-to-rear cover bolts.
4. Remove the rear cover bolts.
5. Remove the rear cover and gasket.
6. Discard the rear cover gasket.
7. Clean and inspect the engine rear cover.
Installation Procedure
Important:
^
Do not reuse the crankshaft oil seal or rear cover gasket.
^
Do not apply any type of sealant to the rear cover gasket (unless specified).
^
The special tool in this procedure is used to center the crankshaft rear oil seal.
^
All gasket surfaces should be free of oil or other foreign material during assembly.
^
The crankshaft rear oil seal MUST be centered in relation to the crankshaft.
^
The crankshaft rear oil seal will be installed after the rear cover has been installed.
^
An improperly aligned rear cover may cause premature rear oil seal wear and/or engine assembly oil leaks.
1. Install the rear cover and gasket.