CTS V8-5.7L VIN P (2004)
9. Important:
^
Do not lubricate the oil seal sealing surface.
^
Do not reuse the crankshaft oil seal.
Lubricate the outer edge of the oil seal (1) with clean engine oil.
10. Lubricate the front cover oil seal bore with clean engine oil.
11. Install the crankshaft front oil seal into the J41478 guide.
12. Install the J41478 threaded rod (with nut, washer, guide, and oil seal) into the end of the crankshaft.
13. Use the J41478 in order to install the oil seal into the cover bore.
^
Use a wrench and hold the hex on the installer bolt.
^
Use a second wrench and rotate the installer nut clockwise until the seal bottoms in the cover bore.
^
Remove the tool.
^
Inspect the oil seal for proper installation. The oil seal should be installed evenly and completely into the front cover bore.
14. Install the generator bracket.
15. Install the accessory drive belt idler pulley.
16. Install the air conditioning belt tensioner.
17. Install the water pump.
18. Install the crankshaft balancer.