CTS V8-5.7L VIN P (2004)
Accelerator Pedal Position Sensor: Service and Repair
ACCELERATOR PEDAL POSITION (APP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the closeout/insulator panel from under the dashboard on the drivers side.
NOTE: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle
control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in
cleaning solvents of any type.
2. Disconnect the accelerator pedal position (APP) sensor electrical connector from the accelerator pedal module.
3. Remove the APP sensor mounting bolts.
4. Remove the APP sensor from the vehicle.
INSTALLATION PROCEDURE
1. Position the APP sensor to the mounting plate.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the APP sensor mounting bolts.
Tighten
Tighten the APP sensor mounting bolts to 9 N.m (80 lb in).
3. Connect the APP sensor electrical connector.
4. Operate the accelerator pedal and observe the APP angles using a scan tool. The accelerator pedal should operate freely, without binding between
closed throttle and wide open throttle.
5. Install the closeout/insulator panel.