CTS V8-5.7L VIN P (2004)
Air Bag: Service and Repair
Roof Rail Module Replacement - Right
INFLATABLE RESTRAINT ROOF RAIL MODULE REPLACEMENT - RIGHT
REMOVAL PROCEDURE
CAUTION:
-
In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the
area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.
-
Refer to SIR Caution in Service Precautions.
-
Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 6.
2. Remove the windshield garnish molding.
3. Remove the center pillar garnish moldings.
4. Remove the rear sail panel.
5. Remove the connector position assurance (CPA) from the harness connector (1) to the inflatable restraint roof rail module.
6. Disconnect the harness connector (1) from the roof rail module.
7. Lower the headliner to gain clearance to the roof rail module.
8. Remove the fasteners (2) from the roof rail module.
9. Remove the roof rail module from the roof.
INSTALLATION PROCEDURE
CAUTION: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is
securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR
system repairs.