CTS V8-5.7L VIN P (2004)
1. Remove any dirt, grease, or other impurities from the mounting surface.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the mounting fasteners to the inflatable restraint roof rail module.
Tighten
Tighten the fasteners to 9 N.m (80 lb in).
3. Install the roof rail module harness connector (1) to the wiring harness.
4. Install the CPA to the roof rail module harness connector.
5. Install the windshield garnish molding.
6. Install the center pillar garnish moldings.
7. Install the rear sail panel.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 6.
9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.