CTS V8-5.7L VIN P (2004)
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the I/P module mounting fasteners.
Tighten
Tighten the fasteners to 9 N.m (80 lb in).
4. Route the I/P module wiring harness in place to secure the I/P module yellow 2-way connector clip.
5. Install the I/P retainer.
6. Install the I/P module yellow connector to the vehicle harness yellow connector.
7. Install the CPA to the instrument panel module connector.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5.
9. After replacing the module, deploy the old module before disposal. If the module was replaced under warranty, fully deploy and dispose of the
module after the required retention period. Refer to Inflator Module Handling and Scrapping for proper disposal.