CTS V8-5.7L VIN P (2004)
Air Bag: Service and Repair
Deployment Inside Vehicle (Vehicle Scrapping Procedure)
DEPLOYMENT INSIDE VEHICLE (VEHICLE SCRAPPING PROCEDURE)
Deploy the inflator modules inside of the vehicle when destroying the vehicle or when salvaging the vehicle for parts. This includes but is not limited to
the following situations:
-
The vehicle has completed its useful life.
-
Irreparable damage occurs to the vehicle in a non-deployment type accident.
-
Irreparable damage occurs to the vehicle during a theft.
-
The vehicle is being salvaged for parts to be used on a vehicle with a different VIN as opposed to rebuilding as the same VIN.
CAUTION: Refer to SIR Inflatable Module Deployment Outside Vehicle Caution in Service Precautions.
1. Turn the ignition switch to the OFF position.
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove all loose objects from the front seats.
5. Disable the SIR system. Refer to SIR Disabling and Enabling Zones.
CAUTION: Refer to Dual Stage Inflator Module Handling Caution in Service Precautions.
6. Disconnect the steering wheel module yellow connector (1) from vehicle harness yellow connector (3).
IMPORTANT: If vehicle is equipped with dual stage air bags the steering wheel module and IP module will each have 4 wires. Refer to SIR
Connector End Views for determining high and low circuits.
7. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
8. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
9. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. Use these wires to fabricate the driver deployment
harness.
10. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
11. Twist together one end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the inflator module.