CTS V8-5.7L VIN P (2004)
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Install the SDM (1) horizontally to the console floor.
3. Point the arrow on the SDM toward the front of the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the SDM mounting fasteners (2).
Tighten
Tighten fasteners to 9 N.m (80 lb in).
5. Connect the wiring harness connector (1) to the SDM.
6. Push the flex lock button (3) down and move the sliding connector locking cover (4) to the CLOSE position.
7. Install the CPA (1) to the wiring harness connector (2) to the inflatable restraint SDM.
8. Install the console.
9. Install the driver and the passenger seats to the original position.
10. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8.
IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to
be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps
thoroughly to ensure that the SDM is set properly.
11. Program the new SDM into the dash integration module. See: Testing and Inspection/Programming and Relearning