CTS V8-5.7L VIN P (2004)
16.
Remove the connector position assurance (CPA) (1) from the wiring harness connector (2) to the inflatable restraint sensing and diagnostic module
(SDM).
17.
Push the flex lock button (3) down and move the sliding connector locking cover (4) to the OPEN position.
Important:
The SDM is shown with the carpet removed for illustration purposes only. Removal of the front carpet or the front seats is not necessary to
service the SDM.
18.
Disconnect the wiring harness connector from the SDM (1).
19.
Remove the SDM mounting fasteners (2).
20.
Remove the SDM from the console floor.
Installation
1.
Remove any dirt, grease, or other impurities from the mounting surface.