CTS V8-5.7L VIN P (2004)
2. Install the fastener (2) while holding the pretensioner in place.
Tighten
Tighten the nut to 42 N.m (31 lb ft).
3. Install the pretensioner trim cover by aligning the tabs. Snap the tabs into place.
4. Install the seat into the vehicle.
5. Carefully route the pretensioner pigtail harness and the seat belt wiring harness under the seat.
6. Connect the pretensioner electrical connector to the side air bag connector.
7. Connect the electrical connector to the seat belt switch.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 or to SIR Disabling and Enabling Zone 9.