CTS V8-5.7L VIN P (2004)
Power Door Lock Switch: Removal and Replacement
Door Lock Switch Replacement
Door Lock Switch Replacement
Removal Procedure
1. Remove the inside handle bezel from the inner door panel in the following order:
1. Hold the inside handle (1) to the open position.
2. Insert a flat-bladed tool at the front lower corner of the bezel.
3. Pry outward on the bezel.
4. Remove the bezel from the inner door panel.
2. Disconnect the electrical connector from the lock switch.
Installation Procedure
1. Snap the door lock switch into the door switch bezel.
2. Connect the electrical connector.
3. Slide the bezel over the door handle.
4. Snap the bezel into position by pushing on lower front corner of bezel.
Front Door Switch Replacement
Front Door Switch Replacement
Removal Procedure
1. Insert a flat-bladed tool under the front edge of the front door switch.
2. Push the tool firmly towards the switch to disengage the retainer.
3. Lift up on the rear of the switch plate to remove it from the door trim panel.