CTS V8-5.7L VIN P (2004)
12. Remove the connector from the sensor.
13. Remove the sensor from the adapter and bearing assembly.
14. To install the sensor, proceed to step 9 in the installation procedure.
15. From the technicians point of view, the FRONT of the sensor will have:
^
A raised rotor flange cuff (3)
^
An alignment mark (2) on the rotor flange cuff (3) for installation
^
A pin hole (1) for the centering pin. Note location of the pin hole.
^
A sensor clip in FRONT of the sensor
16. Remove the connector from the sensor.
17. Remove the sensor clip from the sensor.
18. Remove the sensor from the adapter and bearing assembly.
19. To install the sensor, proceed to step 13 in the installation procedure.
20. From the technicians point of view, the FRONT of the sensor will have:
^
A flush rotor flange cuff (3)
^
A pin hole (1) for the centering pin. Note the location of the pin hole.
^
An alignment mark (2) on the flush rotor flange cuff (3) for installation
21. Remove the connector from the sensor.
22. Remove the sensor from the adapter and bearing assembly.
23. To install the sensor, proceed to step 17 in the installation procedure.
24. From the technicians point of view, the FRONT of the sensor will have:
^
A flush rotor flange cuff (4)
^
A pin hole (2) for the centering pin. Note the location of the pin hole.
^
An alignment mark (3) on the flush rotor flange cuff (4) for installation
^
A foam ring (1)
25. Remove the connector from the sensor.
26. Remove the sensor from the adapter and bearing assembly.
27. To install the sensor, proceed to step 21 in the installation procedure.
Installation Procedure
1. Important:
-
If reusing the existing sensor, no centering of the sensor is required.
-
If installing a new sensor, it will come with a pin installed in the sensor. Do not remove the pin until the sensor is seated.