CTS V8-5.7L VIN P (2004)
Installation Procedure
1. Install the coil spring to the vehicle.
2. Raise the cradle.
3. Install the frame to body mounting bolts (4) and washers (3).
^
Tighten the front bolts to 265 Nm (195 ft. lbs.).
^
Tighten the rear bolts to 191 Nm (141 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
4. Remove the jack from the vehicle.
5. Install a suitable jack under the lower control arm.
6. Using the jack raise the lower control arm until the shock absorber aligns with the knuckle.
7. Install the shock absorber lower retaining bolt.
Tighten the bolt to 150 Nm (111 ft. lbs.).
8. Remove the jack from the vehicle.
9. Install the brake pipe bracket (2) to the mounting studs (1).
10. Install the brake pipe bracket retaining nuts.
Tighten the nuts to 10 Nm (89 inch lbs.).