CTS V8-5.7L VIN P (2004)
6. Ensure the washer solvent container is positioned over the stud (2) on the tie bar outer reinforcement panel.
NOTE: Refer to Fastener Notice in Service Precautions.
7. Install the fasteners (1,4,10) to the washer solvent container.
Tighten
Tighten the fasteners (1,4,10) to 6 N.m (53 lb in).
8. Secure the clinch nut.
Tighten
Tighten the clinch nut to 6 N.m (53 lb in).
9. Secure the horizontal bracket nut.
Tighten
Tighten the horizontal bracket nut to 6 N.m (53 lb in).
10. Connect the washer hose (9) to the washer pump (8).
11. Connect the electrical connector to the washer pump.
12. Connect the electrical connector to the washer solvent level sensor.
13. Install the headlamp.
14. Install the front bumper fascia.
15. Install the front air deflector.