CTS V8-5.7L VIN P (2004)
1. Install the wiper blade onto the wiper arm.
2. Position the passenger side wiper arm so the wiper blade tip (1) aligns with the orange dot on the lower outer edge of the windshield.
3. Position the driver side wiper arm so that the wiper blade tip (4) aligns with the orange line on the lower center of the windshield.
4. Install the wiper arm onto the drive shaft.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: Hold the wiper arm into position while tightening the nut.
5. Install the nut (3,6) on the wiper arm.
Tighten
Tighten the nut to 35 N.m (26 lb ft).
6. Connect the hood assist rods to the assist rod ball studs (1) on the hood assembly.
7. Install the wiper nut covers.
8. Close the hood.