CTS V8-5.7L VIN P (2004)
Wiper Motor: Service and Repair
Wiper Motor Module Grommet Replacement (RHD)
WIPER MOTOR MODULE GROMMET REPLACEMENT (RHD)
REMOVAL PROCEDURE
1. Remove the wiper motor fuse. The wiper motor fuse is located in the underhood fuse block.
2. Remove the wiper arm assemblies.
3. Remove the air inlet grille (1,3).
4. Remove the wiper motor module mounting bolts (3,5).
5. Disconnect the wiper motor electrical connector (4).
6. Remove the wiper motor module (1) from the vehicle.
7. Remove the following grommets from the wiper module:
-
round (2)
-
oval (5)
-
pin (7)
INSTALLATION PROCEDURE
1. Install the following grommets to the wiper motor module:
-
round (2)
-
oval (5)
-
pin (7)