CTS V8-5.7L VIN S (2005)
26. Position and align the yellow push-in retainer to the net hole located in roof panel above the overhead console.
27. Apply moderate hand pressure to the overhead console (1) in order to seat the push-in retainer.
Notice: refer to Fastener Notice in Cautions and Notices.
28. Secure both side assist handles (9) in order to hold the headliner in place.
Tighten the assist handle screws to 2 Nm (18 lb in).
29. Install the assist handle bezel covers.
30. Install the fastener (3) for the rear dome lamp (1).
Tighten the fastener to 10 Nm (88 lb in).
31. Secure the bezel cover (2).
Notice: refer to Fastener Notice in Cautions and Notices.
32. Secure both sunshades.
Tighten the outer sunshade bezel fasteners to 2 Nm (18 lb in).
33. Secure the right side sunshade rod retainer.
Tighten the right side to 10 Nm (88 lb in).
34. Secure the left side sunshade rod retainer.
Tighten the left side to 2 Nm (18 lb in).
35. Position the sunshades to the headliner.
36. Connect the electrical connectors to the inside rearview mirror.
37. Connect the connector lead (3) for the antenna module to the front windshield (2).