CTS V8-6.0L (2007)
Shift Solenoid: Service and Repair
Reverse Lockout Solenoid Replacement
Reverse Lockout Solenoid Replacement
Tools Required
J 41099 Skip Shift Sensor Remover/Installer
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the exhaust system.
3. Support the transmission with a suitable jack.
4. Remove the transmission support.
5. Remove the transmission mount.
6. Disconnect the reverse lockout solenoid electrical connector (5).
7. Using the J 41099, remove the reverse lockout solenoid.
8. Remove the bolt and the reverse lockout assembly, if necessary.
Installation Procedure