CTS RWD V6-3.6L (2008)
3. Install the EBCM screws (1).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Tighten the EBCM screws in the sequence shown (1-4).
Tighten the screws to 3 N.m (26 lb in).
5. Connect the EBCM electrical connector.
6. Position the washer solvent container and install the fasteners. Refer to Windshield Washer Solvent Container Replacement (Minus CE4) (See:
Wiper and Washer Systems/Windshield Washer Reservoir/Service and Repair/Windshield Washer Solvent Container Replacement (Minus CE4)
)Windshield Washer Solvent Container Replacement (With CE4) (See: Wiper and Washer Systems/Windshield Washer Reservoir/Service and
Repair/Windshield Washer Solvent Container Replacement (With CE4)) .
7. Install the front air deflector shield. Refer to Front Air Deflector Replacement (See: Body and Frame/Spoilers, Flaps, and Air Dams/Air
Dam/Service and Repair/Front Air Deflector Replacement) .
8. Lower the vehicle.
9. If installing a new EBCM, program the EBCM. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) .
10. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) .