cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Correction 1|Page 15461 > < Correction 1|Page 15459
Page 7
background image

9. Connect the electrical connector to the handle.

10. With the door handle in the open position, install the door lock cap.
11. Install the bolt that retains the lock cylinder cap.
12. Install the door trim.

13. When installing the trim screws, start with number one closest to the doc-n-loc connector.

Tighten
Tighten the screws to 2 Nm (18 lb in).

14. Clear codes.

Correction 4

Correction 4

Outside Mirrors and/or Power Windows are Inoperative (inspect the dock and lock connector)

Note
If the dock and lock connector on the door is loose, replace the retainer that holds the wire end connector to the panel. 

1. Remove the door trim. Refer to Front Side Door Trim Panel in SI.
2. Remove the dock and lock assembly from the door and connect the assembly to the door trim. A click noise will be heard.
3. Reinstall the door trim. Refer to Front Side Door Trim Panel in SI.
4. When installing the trim screws, start with the one closest to the doc-n-loc. 
5. Check the operation of the outside mirrors and power windows. If the concern is still present, refer to diagnostic information in SI.
6. If the condition is still present after performing all of the above steps check for intermittent power and ground or GMLAN Serial DATA at the

door zone module refer to SI if necessary.

Technical Service Bulletin # 09-08-64-036

Date: 091202

Body - Intermittent Front Door Lock Op. In Cold Temps.

TECHNICAL

Bulletin No.: 09-08-64-036

Date: December 02, 2009

Subject: Intermittent Front Door Lock Operation During Freezing Temperatures (Install Revised Door Lock)

Models:

2008 Cadillac CTS
2009 Cadillac CTS (with RPO UHA or UHF), CTS-V

Condition

Some customers may comment on any of the following conditions:

-

One or both front doors may not open using the outside door handle in sub-freezing conditions (the door can still be opened using the inside
release handle).

-

One or both front door may open, but then not close and re-latch in sub-freezing conditions (the DIC will indicate that the door is ajar or open).

-

The door lock is frozen.

In all cases, normal function resumes when the vehicle warms up. These conditions may exhibit themselves after a car wash and/or driving on wet roads,
and subsequently being exposed to sub-freezing temperatures.

Cause

Correction 1|Page 15461 > < Correction 1|Page 15459