CTS RWD V8-6.2L SC (2009)
5. Position the passenger side air inlet grille panel three integral clips under the driver side air inlet panel.
6. Position to the air inlet grille panel to the plenum.
7. Install the screws (1) in order to secure the air inlet panel to the plenum and tighten to 3 Nm (27 lb in).
8. Install the rear hood seal onto the hem flange of the air inlet grille panel.
9. Apply palm pressure across the seal in order to secure.
10. Install the windshield wiper arms. Refer to Windshield Wiper Arm Replacement (See: Wiper and Washer Systems/Wiper Arm/Service and
Repair).
11. Close the hood.