CTS RWD V8-6.2L SC (2009)
1. Reconnect the camshaft sensor (5) and the jumper harness (4).
2. Install the O-ring (6) on the camshaft sensor assembly (4 and 5).
3. Reconnect the camshaft position sensor assembly (4, 5 and 6) and the engine harness connector (3).
Note: Before installing the camshaft sensor assembly, apply a small amount of clean motor oil to the O-ring (6).
4. Install the camshaft position sensor assembly (4, 5 and 6) in the front cover (7).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. Install the camshaft position sensor mounting bolts and tighten to 25 Nm (18 lb ft).
6. Install the generator assembly. Refer to Generator Bracket Replacement (SFI) (See: Starting and Charging/Charging System/Alternator/Service
and Repair/Generator Bracket Replacement)Generator Bracket Replacement (V8) (See: Starting and Charging/Charging
System/Alternator/Service and Repair/Generator Bracket Replacement).