CTS RWD V8-6.2L SC (2009)
7. Support the starter motor.
8. Remove the starter motor bolts.
9. Remove the starter motor.
Installation Procedure
1. Position the starter motor to the block.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the starter motor bolts and tighten to 50 Nm (37 lb ft).
3. Install the wire and positive assurance pin to the starter solenoid.
4. Install the battery positive cable to the starter terminal.
5. Install the battery positive cable to starter terminal nut and tighten to 10 Nm (89 lb in).
6. Install the inboard exhaust manifold to catalytic converter stud and tighten to 25 Nm (18 lb ft).
7. Install the right side catalytic converter. Refer to Catalytic Converter Replacement - Right Side (V6) (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair)Catalytic Converter Replacement - Right Side (V8) (See: Engine, Cooling and Exhaust/Exhaust