CTS RWD V8-6.2L SC (2009)
6. Using a socket wrench, turn bolts 5 and 6 360 degrees.
7. Return to bolts 1 and 2 and rotate 360 degrees.
8. Return to bolts 3 and 4 and rotate 360 degrees.
9. Return to bolts 5 and 6 and rotate 360 degrees.
10. Repeat Steps 7.7 through 7.9 until the clutch pressure plate is flat against the flywheel
11. Remove the clutch alignment tool.
12. Torque the bolts to 70 Nm (52 lb ft). in the numbered sequence shown.
9. Install the bell housing bolts and tighten to 50 Nm (37 lb ft).
10. Install the driveline support assembly and the transaxle. Refer to Front Frame Replacement (Rear Wheel Drive) (See: Body and
Frame/Frame/Subframe/Front Subframe/Service and Repair)Front Frame Replacement (All Wheel Drive) (See: Body and
Frame/Frame/Subframe/Front Subframe/Service and Repair).
11. Lower the vehicle.
12. Connect the negative battery cable and tighten the cable fastener to 15 Nm (11 lb ft).