CTS Sedan AWD V6-3.0L (2010)
14. Pull the right side transmission support down only enough to allow removal of the chassis fuel hose/pipes.
15. Partially lower the hoist only enough to simultaneously gain access to both the front and rear portions of the chassis fuel hose/pipes.
16. With the aid of an assistant, carefully guide the chassis fuel hose/pipes down through the engine compartment, removing from the bottom.
Installation Procedure
1. Clean any of the contamination from the male line ends and apply a few drops of clean engine oil.
2. With the aid of an assistant, carefully guide the chassis fuel hose/pipes up through the engine compartment into position.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
4. Pull the right side transmission support down only enough to allow installation of the chassis fuel hose/pipes.
5. Install the transmission support right side bolts. Refer to Transmission Support Replacement (Manual except CTS-V) (See: Body and
Frame/Frame/Cross-Member/Rear Cross-Member/Service and Repair)Transmission Support Replacement (Automatic RWD except CTS-V) (
See: Body and Frame/Frame/Cross-Member/Rear Cross-Member/Service and Repair)Transmission Support Replacement (Automatic CTS-V) (
See: Body and Frame/Frame/Cross-Member/Rear Cross-Member/Service and Repair)Transmission Support Replacement (Manual CTS-V) (See:
Body and Frame/Frame/Cross-Member/Rear Cross-Member/Service and Repair)Transmission Support Replacement (Automatic AWD) (See:
Body and Frame/Frame/Cross-Member/Rear Cross-Member/Service and Repair).