CTS Sedan AWD V6-3.0L (2010)
Tip
Remove the control switch from the back of the bezel by releasing the four plastic retaining tabs with a small screwdriver.
-
If the steering wheel lower spoke cover (3) needs to be replaced, proceed to Step 3.
3. Remove the two TORX(R) screws from the steering wheel lower cover.
4. Remove the center steering wheel lower spoke cover from the steering wheel assembly.
5. Install the new steering wheel lower spoke cover onto the steering wheel.
6. Install the two TORX(R) screws into the new cover.
Tighten
Tighten the two screws to 2 Nm(18 lb in).
7. Connect the two electrical connectors to driver's side airbag module and seat the assurance (CPA) retainers.
8. Install the airbag module into the steering wheel and seat the module.
9. Enable the SIR system. Refer to SIR Disabling and Enabling in SI.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer