cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Differential Case > < Differential Carrier|Service and Repair
Page 2
background image

Note:  
*

The intermediate wheel drive shaft and the differential are to be installed removed as a assembly.

*

In order to prevent lubricant leaks, use care when installing the wheel drive shaft to the differential. Do not damage the oil seal. Replace the oil
seal if it becomes nicked, distorted, or is otherwise damaged.

1. Position the differential on a transmission jack.
2. Firmly secure the differential to the transmission jack.
3. With the differential firmly attached to the jack, install the intermediate wheel drive shaft and the front differential to the oil pan.

Caution:  Refer to Fastener Caution   (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).

4. Install the front differential to oil pan mounting bolts and tighten in sequence (1-3) to 110 Nm (81 lb ft).
5. Remove the transmission jack from the differential.
6. Install the intermediate wheel drive shaft support bearing. Refer to Front Wheel Drive Intermediate Shaft Bearing Replacement   (See: Drive

Axles, Bearings and Joints/Axle Shaft Assembly/Support - Half Shaft/Short Shaft/Service and Repair).

7. Install the left front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Right Side   (See: Drive Axles, Bearings and Joints/Axle

Shaft Assembly/Service and Repair).

8. Install the right front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Right Side   (See: Drive Axles, Bearings and Joints/Axle

Shaft Assembly/Service and Repair).

9. Install the front propeller shaft to the differential. Refer to Front Propeller Shaft Replacement   (See: Drive/Propeller Shafts, Bearings and

Joints/Drive/Propeller Shaft/Service and Repair/Front Propeller Shaft Replacement).

10. Inspect the differential lubricant level. Refer to Front Axle Lubricant Level Inspection   (See: Fluid - Differential/Service and

Repair/Procedures/Front Drive Axle).

11. Install the front frame assembly. Refer to Drivetrain and Front Suspension Frame Replacement (All Wheel Drive)   (See: Body and

Frame/Frame/Subframe/Front Subframe/Service and Repair)Drivetrain and Front Suspension Frame Replacement (Rear Wheel Drive)   (See:
Body and Frame/Frame/Subframe/Front Subframe/Service and Repair).

12. Lower the vehicle.

Differential Case > < Differential Carrier|Service and Repair