CTS Sedan AWD V6-3.0L (2010)
5. Install the stationary window post bolt and tighten to 9 Nm (80 lb in).
6. Push the glass forward into the front glass run channel.
Note: Start the vehicle in order to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.
7. Start the vehicle.
8. Using the power window switch, raise the window to the full up position. Tighten the window clamp nuts to 11 Nm (98 lb in).
9. Inspect the window for proper operation and a tight seal.
10. Shut off the vehicle.
11. Install the rear side door stationary window. Refer to Rear Side Door Stationary Window Replacement (See: Rear Side Door Stationary Window
Replacement).
12. Install the window outer belt sealing strip. Refer to Rear Side Door Window Outer Sealing Strip Replacement (See: Service and Repair/Rear Side
Door Window Outer Sealing Strip Replacement).
13. Install the window inner belt sealing strip. Refer to Rear Side Door Window Inner Sealing Strip Replacement (See: Service and Repair/Rear Side
Door Window Inner Sealing Strip Replacement).
14. Install water deflector.
15. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement (See: Body and Frame/Doors, Hood and Trunk/Doors/Rear
Door/Rear Door Panel/Service and Repair/Rear Side Door Trim Panel Replacement).