CTS Sedan RWD V6-3.0L (2010)
J 45017 Output Shaft Seal Installer
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the right front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Right Side (See: Drive Axles, Bearings and
Joints/Axle Shaft Assembly/Service and Repair).
3. Using a flat-bladed tool, remove the right differential output shaft seal (1).
Installation Procedure
1. Lubricate the wheel drive shaft sealing surface of the oil seal with 75W90 synthetic axle lubricant, GM P/N 12378261 (Canadian P/N 10953455)
or equivalent.
2. Install the right differential output shaft seal (2) to the J 45017 .
3. Using the J 45017 (1), install the right differential output shaft seal (2).
4. Remove J 45017 (1) from the right differential output shaft seal (2).
5. Install the right front wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement - Right Side (See: Drive Axles, Bearings and Joints/Axle
Shaft Assembly/Service and Repair).
6. Inspect the fluid level. Refer to Rear Axle Lubricant Level Inspection (See: Fluid - Differential/Service and Repair/Procedures/Rear Drive Axle).
7. Lower the vehicle.