CTS Wagon RWD V8-6.2L SC (2011)
9. Twisting the clip with the needle nose pliers will help access the tabs. Use a small screwdriver to release to two outer tabs on the metal retainer and
remove the retainer from the vehicle.
10. Insert the new service retaining clip into the garnish molding. Ensure the clip is fully seated into the molding.
11. Insert the lower mounting tabs into the top of the instrument panel. No gap should be present between the molding and the top of the instrument
panel.
12. Insert the retaining clip into the body and ensure that the clips are fully seated. Inspect the upper molding area and verify that there is no gap at the
headliner.
13. Enable SIR system. Refer to SIR Disabling and Enabling in SI.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer